How to Make an Origami Jumping Frog
The traditional jumping frog: press its back and it leaps. Two collapses and an inside reverse fold make the legs.
- Difficulty: Easy (2 of 5)
- Time: about 15 minutes
- Paper: 15 cm (6 in) square, thick paper jumps best
Steps
- Lay the paper white side up. Fold the bottom edge to the top edge, press the crease, then open it back out.
- Fold the left edge across onto the right edge, and leave it folded.
- Fold the folded edge across to the right edge once more, through all the layers. Press the crease, then open it back up.
- Flip the paper over.
- Fold the bottom edge up to the crease across the middle, through all the layers. Press the crease, then open it back up.
- Flip the paper back to white side up.
- Fold the bottom-left corner up and to the right so the bottom edge lies along the right edge. Press the crease, then open it back up.
- Fold the bottom-right corner up and to the left so the bottom edge lies along the left edge. Press the crease, then open it back up.
- In one movement, push the two lower sides inward and swing the bottom edge up to the crease across the middle.
- Fold each top flap down and outward, starting at the middle of the top edge. Make the two folds a matching pair: they are the front legs.
- Rotate the model half a turn.
- Fold the bottom edge up to the line where the front legs begin.
- Lift the front legs aside. Fold the left and right edges in to the center line, then lay the legs back down.
- Fold the bottom edge up to the spot where the front legs meet.
- Fold the two slanted edges of this flap down onto its lower edge. Press the creases, then open both back out.
- Open the bottom flap back out.
- Raise the two lower side flaps, then push the bottom edge up toward the spot where the front legs meet. The side flaps swing outward as it rises.
- Lay the left and right flaps down on the creases they already have.
- Fold the inner edge of each lower flap outward to the closest crease. These two flaps are the back legs.
- Fold the whole lower section upward, hinging on the line where the front and back legs meet.
- Fold the flap you just raised in half, top down onto its base. Press this crease hard: the pleat is the frog's spring.
- Flip the frog over.
- Spread the back legs a little so the frog sits on the table. Press down on its back, then slide your finger off and it leaps!
Model: Traditional design; step sequence and wording by FoldLab